|
Single Shaft Shredder For Recycling Plant Areas of Application:
The single shaft shredder, type TIGER is used in recycling operations for the production of valuable secondary raw materials. The feed material should be in pieces in order to be metered into the machine. Whereby, it does not make any difference to the TIGER whether or not it is fed with old tire chips or electronic waste. It does neither sneeze at used telecommunication equipment and cables nor at circuit boards, waste bins and safety floor coverings. Anywhere where roughest conditions exist and reliability is required, a TIGER is found im action.
Method of Operation:
The single shaft shredder, type TIGER size reduces all cuttable material to a particle size smaller than 20 mm or when necessary coarser. Material is normally fed by means of a conveyor belt or vibratory feeder across the entire width of the machine. Massive, serrated rotor tearing elements work the material between the stator serrations. The tearing elements do not require re-sharpening, due to the regular reversing action of the rotor they are self sharpening. Excact working gap settings are not required in order to achieve good results and only the stators must be adjusted at specific intervals. A well dimensioned screen is installed in the lower part of the housing, which retains the material in the cutting chamber until it is discharged straight down out of the machine into a mechanical conveying system. The installation of an auxiliary exhaust system is recommended.
Design:
This sturdy and compactly built machine is designed for the special requirements of modern recycling operations. Excellent accessibility to the cutting chamber by means of large front doors. Rotor and stator tearing elements are clamped by means of wedges and are self sharpenig by means of the regular reversing action of the rotor. Extensive adjustments inside the machine are not necessary. The screen frame is opened hydraulically and the screen is reversible, for even usage of both sides. The massive pedestal bearings made out of solid steel are supported sideways by the housing and the safety devices are in compliance with current machine builders directives.
|
